All of our Wax Melts are hand made using premium soy wax and formulated to give you the maximum fragrance load for ultimate performance.

 

TIPS AND TRICK FROM US TO YOU

1. Place your warmer as close to the centre of the room you want to fragrance as possible. 
2. Make sure your warmer is placed on a heat resistant surface away from children and pets. Also ensure any cords are tucked away or do not hang over the surface where it can be pulled off the surface or table.
3. For a small dish place 1 melt bar, and for larger or wider dishes place 2 melt bars.
4. Turn on your electric warmer, it may take up to 20 minutes for the wax to fully melt as the wax melts the fragrance will start to flow filling your room with fragrance. 
5. After 2 or 3 hours turn off your wax warmer as your nose will be used to the smell. The scent will still linger for quite a while then wait a few hours then turn it back on again. This will make each wax melt last longer.
6. After use turn off your electric warmer and make sure the wax is completely hard before moving or touching the warmer as the wax and the warmer will be hot.
7. To change the wax to a different fragrance turn your warmer on for about 2 minutes then the wax should simply slip out of the dish with a little push. Then give the dish a wipe out with a paper towel then you are ready for a new fragrance.
8. Just because a fragrance in a large room may have faded keep your wax and use it in a smaller sized room as there may still be enough fragrance left to fragrance a smaller sized room.

 

Melts Safety:

Due to the high amount of fragrance in this product it should not be used with a direct flame and must only be used in a traditional oil burner or electric melt warmer. If the fragrance becomes too strong for you simply turn off the melter and ventilate the room. Always follow the safety instructions that came with your product to ensure safe, proper use.